Oxy-hydrogen generator source:
Electricity flows to the Adjustable Transformer Controller; The alternating current then goes into the Commutator, and transforms into direct current.
The direct current connects to the anode "+", and cathode "-" in the electrolytic cell, to electrolyze water into pure hydrogen and oxygen.
As the Oxyhydrogen gas passes through the filter and pressure detector, the flame device (with antibackfire safety valve) ignites to a temperature between 800 and 3200 degrees centigrade.
It can be used for precision cutting processing equipment, giving results that are economical, reliable, safe, and environmental.
Some oxy-oxy-hydrogen Advantages — Cutting of Iron/steel:
Oxy-hydrogen Flame can punch holes in iron/steel and other materials without additional oxygen. The gas already contains all the oxygen it needs to burn perfectly.
Oxy-hydrogen holes have very little taper (compared with fuel-gasses) and 'throwback' significantly less material when punching through iron/steel.
Oxy-hydrogen Flame cones are long, allowing the torch to be held farther away from the work. This results in virtually no torch cleaning maintenance or tip damage.
Oxy-hydrogen Flame cuts iron much faster than any other torch gas on a BTU to BTU basis.
Oxy-hydrogen Flame will cut thicker iron with the same torch tip and oxygen pressures.
Oxy-hydrogen Flame will cut the same thickness of steel using a smaller torch tip. This allows for faster, cleaner cuts with less kerf.
Oxy-hydrogen Flame cuts from 10% to 25% faster with excellent quality and no slag or dross.
Technical Data Sheet
|Voltage(V)||380 ±10%,50/60Hz,three phase|
|Rated gas output(L/H)||3000±10%||5000±10%||7000±10%||10000±10%|
|Maximum Cutting Thickness(mm)||110||220||310||420|
|Effective perforated thickness(mm)||40||60||70||90|
|Cooling way||Air cooling|
|power protection grade||IP2S|
|Flame temperature(T)||800-3200 adjustable|
|Working medium||Filtered water or deionized water or soft water|